Technical data
Table Of Contents
- 0. i Cover B
- 0. i Copyright B
- 0. i TOC B
- 1. i Introduction B
- 2. i Programming Concepts B
- 3. i Code Quick Reference B.backup
- 4. i Standard Command Codes B
- 5. i Optional Command Codes B
- 6. i Bi-Directional Communications B
- 7. i Appendix B
- 7
- appendix
- custom graphics
- CUSTOM GRAPHICS EXAMPLE
- 1. Determine the matrix size for the graphic. It must be in 8 dot by 8 dot blocks. The example here has six blocks horizontally and six blocks vertically (48 x 48).
- 2. Lay out a grid and draw the image on the grid.
- 3. Transfer the image into a bit map representation and then into hexadecimal format:
- 4. Using the hexadecimal data, send the following code to print the graphic image as designed.
- 5. To send the data in binary format, the software must convert the data into binary format before transmitting it to the printer. Using the BASIC programming language for example, this is done by notation “CHR$ (&HC0)” which sends the hexidecima...
- PCX GRAPHICS EXAMPLE
- CUSTOM GRAPHICS EXAMPLE
- printer configuration commands
- reference tables
Unit 2: Programming Concepts
i Programming Reference
2-5 PN: 9001158B
PRINT POSITION COMMANDS
There are three methods using command codes to properly orient print images on a label. They are as follows:
MEDIA SIZE COMMAND
The Media Size Command (<ESC>A1) allows specification of the label width and length so the printer may
autmatically adjust itself relative to the command entry. However, the label size specified and the actual label size
must match.
EXAMPLE: <ESC>A1aaaaabbbb
a = Label Length
b = Label Width
Figure 2-1, Media Measurement
BASE REFERENCE POINT COMMAND
The Base Reference Point Command (<ESC>A3) establishes the zero point of the Horizontal and Vertical axis so
the distance may be calculated in dots from that point to the label’s edge. This command immediately follows the
Data Start Command.
EXAMPLE: Label Width = total dots - = 406 dots
New Base Ref Point = Max Print Width - Label Width
= (dot quantity) - (406 dots) = 426 dots
Issue Base Reference Point command <ESC>A3 after the data Start command.
<ESC>A<ESC>A3H0426V0001. . . . . .
LABEL
Label Width
Label Length