Technical data

Unit 7: Troubleshooting
Page 7-4 PN 9001190C MB400i/MB410i Operator Manual
* Contact your nearest dealer or SATO representative for support
WARNING: Never connect or disconnect interface cables (or use a switch box) with power applied to either
the printer or the host. This may cause damage to the interface circuitry and the damage is not covered by
warranty.
Blink (green-
>off->red->off)
every 1s
All modes Head overheat
protection
feature
When print head
is hotter than
158 degrees F
(70 degrees C),
the print head
overheat
protection
feature is
activated. Not in
error.
Cleared when the
head temperature
drops to 122
degrees F (50
degrees C).
STATUS LED MODE DESCRIPTION CAUSE REMEDY