Technical data

Unit 4: Operation and Configuration

MB400i/MB410i Operator Manual PN 9001190C Page 4-9

USB 1.1 SPECIFICATIONS

The Universal Serial Bus (USB) interface is a factory installed option that must be specified at the

time of order. It required a driver (shipped with each printer that has the interface installed) that

must be loaded on your PC and the PC must be configured to support USB peripherals using

Microsoft Windows. Details for loading the USB driver are contained in the USB Interface

manual that is shipped with each printer with a USB Optional interface installed. Up to 127

devices may be connected to a USB port.

PRINTING VIA THE OPTIONAL WIRELESS LAN INTERFACE

To print using the Wireless LAN MB400i/410i, you need to have a properly configured wireless

LAN set up. The next step is to configure the MB400i/410i to share the same network settings in

order to establish communication.

1. Check the DIP Switches:

The printer’s DIP switches are factory set for WLAN operation. Check that DIP switch 1 is

OFF and DIP switch 2 is ON. In case you need to reset other switches, refer to the DIP-Switch

settings in the table, Enabling and Disabling Special Functions, in the chapter, Operating

Modes.

USB 1.1 SPECIFICATIONS

Transfer Rate 11Mbits per second

Communication Control STATUS3 return

Code type ASCII character code, JIS Kanji code

Connector Mini B type

Max. Receive buffer 128 KB

When implementing the flow control into the hardware, the flow

control will activate when "buffer full" is detected and deactivate

as soon as "buffer full" is released. During that span the flow

control manages the information flow and prevents a buffer

overflow.

Near full

occured

Near full

released

0MB

128KB

Remaining 24K

Remaining 52KB