Technical data

Unit 3: Setup
Page 3-18 PN 9001190C MB400i/MB410i Operator Manual
Figure 3-26, Sliding Tear-off Bar
8. With the printer’s operations panel facing you, hold it with two hands, and put your thumbs
on the two sets of parallel bars molded in the Dispenser unit on either side of the dark gray
Cover Release Lever. Push away from you toward rear of unit, using your thumbs, until it
stops sliding.
If the linerless label clogs at the dispenser, clear the label and re-load the label.
This completes the label installation for Dispense mode operation. To resume operation in
Continuous mode, with the printer operations panel facing you, lift the Tear-off bar of the
dispenser unit (where two arrow marks are imprinted) to move it downward toward you. In
Continuous mode, the red platen roller will be visible.