Technical data

Unit 3: Setup
MB400i/MB410i Operator Manual PN 9001190C Page 3-3
PART NAMES
Figure 3-2, Parts Identification
*
1
Only the WLAN model comes with an LCD screen.
N
OTES:
MB400i/MB410i series have an option to install a set of rubber boots to the exterior at the factory.
The appearance is similar, except on two sides. This document shows the picture of the printer
without the rubber boot installed.
0/7%2BUTTON
,#$

)NFRAREDCOMMUNICATIONSENSOR
02).4BUTTON
&%%$BUTTON
34!453,%$
"ATTERYCHARGING
INDICATOR,%$
%ASYCUTTER
-AINCOVER
#OVERRELEASELEVER
$ISPENSERUNIT
23#COVER
$#INPUTTERMINALCOVER
"ATTERYCOVER
,ABELDISPENSER
53"$)0SWITCHCOVER
PO WER b utton
LCD *
1
Infrared communication sensor
PRINT b
utton
FEED b
utton
ST A T U S (LED)
Batter y charging
indicator (LED )
Main co ve r
Co ver release lever
Dispenser unit
RS-232C cover
DC input terminal cover
Battery cover
Label dispenser
USB/DIP switch cover
Tear-o ff bar
PO WER button
LCD *
1
Infrared communication sensor
PRINT b
utton
FEED b
utton
ST ATUS (LED)
Battery charging
indicator (LED)
Main cove r
Co ver release lever
Dispenser unit
RS-232C cover
DC input terminal cover
Battery cover
Label dispenser
USB/DIP switch cover
Tear-off bar
PO WER button
LCD *
1
Infrared communication sensor
PRINT b
utton
FEED b
utton
ST ATUS (LED)
Battery charging
indicator (LED)
Main cove r
Co ver release lever
Dispenser unit
RS-232C cover
DC input terminal cover
Battery cover
Label dispenser
USB/DIP switch cover
Tear-off bar