User's Manual

2
Thank you for your purchase of the SATO barcode printer MB400.
This manual helps first time users understand the basics of the MB400 in a short period
of time.
To get the most out of the functions of the MB400, make sure to read this manual
carefully.
Warning!
1. This manual may not be reproduced whole or in part without prior consent from
SATO.
2. The information in this manual is subject to change without notice.
3. Despite this manual has been created to be as accurate as possible, contact the shop or
the dealer where you purchased this product if you find any errors or mistakes.
Introduction
This device complies with Part 15 of the FCC Rules.Operation is subject to the following
two conditions:(1)This device may not cause harmful interference,and(2)This device
must accept any interference received,including interference that may cause undesired
operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device,pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation.This equipment generates use and can radiate radio
frequency energy and,if not installed and used in accordance with instructions,may
cause harmful interference to radio communications.However,there is no guarantee
that interference will not occur in a particular installation.If this equipment does cause
harmful interference to radio or television reception,which can be determined by
turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to whcih the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.