User's Manual

17
Before Starting
Notice
• If the indicator on the charger does not light up, make sure that the battery pack is
firmly attached to the charger. The battery may not charge, if not firmly attached.
• If an already charged battery pack is inserted into the charger, the CHARGE indicator
will turn red once (charging), however it will soon change to green (fully charged).
• If charging a battery pack that has not been used for a long period, the indicator on the
charger will flash for a while. This does not indicate an error, and you can continue
charging as it is. If the indicator continues to flash for a long time while charging,
replace the battery pack with a new one.
• The battery pack can be charged up to 300 times (during use in regular temperatures).
If the battery pack is fully charged but soon runs out, replace the
battery pack with a new one.
* Write down the date of purchase of the battery with a marker on
the sticker attached to battery pack as a guideline of the number
of times the battery can be recharged (the life of the battery). (For
example: Date of purchase: Jun. 1st, 2002.)
• The battery pack cannot be used when using the AC adapter.
If the AC adapter jack is plugged into the printer when using the battery, the power
will be reset.
(If there is any remaining print data, it will be lost.)
Charging time
The duration of one battery pack from empty until fully charged is about 90
minutes. For two battery packs about 130 minutes.
(The charging time varies depending on the environment.)
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer's instructions.
Dispose of used batteries according to the manufacturer’s instructions.
DATE Jun/1/2002