Technical data

Unit 4: Operation and Configuration
Page 4-32 MB400i/MB410i Operator Manual
OFFSET CONFIGURATION VIA PROGRAMMING
The following offset adjustments for the MB400i/410i printer are usually unnecessary. Almost all
adjustments are electrical in nature due to the printer’s advanced self aligning and balancing
design features. However, if you need to perform the adjustments, they can be sent as
commands to the printer. Consult your SATO representative for information on programming the
MB400i/410i printer, or refer to the Programming Reference guide found on the CD-ROM.
Table 4-6, Position Adjustments
POSITION ADJUSTMENTS
Adjustment Method Description
Printer Setting
Commands
Use the <PG>
programming
command.
Saves the values to
the Flash ROM.
Base Point Offset
Pitch Offset
Dispense Offset
Tear-Off Offset
Base Point Offset Use the <A3>
programming
command.
Takes effect instantly;
the value is cleared
once the power is
turned off.
Pitch Offset Use the <PO3>
programming
command.
Takes effect instantly;
the value is cleared
once the power is
turned off.
Dispense Offset Use the <PO1>
programming
command.
Takes effect instantly;
the value is cleared
once the power is
turned off.
Tear-Off Offset Use the <PO2>
programming
command.
Takes effect instantly;
the value is cleared
once the power is
turned off.