Specifications

MB200 Quick Guide Pg 9
First perform the previous Steps 1 to 5. (Continuous Mode)
1. Pick the Dispense/Continuous switch lever from both
sides, and slide the dispenser unit to the direction of
the arrow.
Leave more than 30mm of the label out for the
dispense mode.
Slide the dispenser unit until it is in place.
Always set the dispenser unit back to the
Continuous mode when opening/closing the cover.
MB200 Quick Guide Pg 6
Using the AC Adapter
Plug the specified AC adapter (optional) into the printer.
1. Take off the DC input jack cap and plug the AC
adapter into the DC input jack.
2. Plug the AC adapter into the outlet.
* Always turn off the printer when unplugging the AC adapter or DC output jack, or
when disconnecting the power source.
When turning off the printer, the status indicator lights up in green. Do not
disconnect the power source while this light is on. Always make sure the green
light is off when disconnecting the power supply.
* When the power source is disconnected while the green light is on, the data in the
printer memory may not be refreshed.
At the Continuous Mode (STD)
At the Dispense Mode (DSP)