Specifications

MB200 Quick Guide Pg 7
Media Loading
Setting Labels
The method of setting the labels may vary depending on the print mode.
Remove the protection case.
1. Place your fingers on the open cover ribbed area,
and slide the cover Open/Close lever in the
direction of the arrow.
2. When the open cover pops open, fully open the
cover in the direction of the arrow.
3. Place the label roll on the spindle on the open
cover side. When inserting the label roll, make
sure to press down the label core to prevent the
labels from raveling out. When removing
remaining labels, insert your finger in the label
core and remove the label with the core to
prevent the labels from raveling out.
MB200 Quick Guide Pg 8
4. After peeling the leading tape on the roll, take the
leading edge of the first label of the roll and pull it
out from the label ejection via the platen roller.
Adjust the label guide (left) to the label size, and
pass the label underneath the label guides.
5. Place your fingers on the open cover ribbed area
and close the open cover.
This completes the setting of the labels when using the
Continuous mode.
Label set
position