Technical data

Unit 1: Introduction
SATO MB200 Operator Manual PN 9001126A Page 1-3
SWITCHES AND INDICATORS
The table below identifies and defines printer switches and indicators for operator interface. The
accompanying graphics display their locations and appearance
CONNECTION PORTS
These ports are externally accessable and permit connection of the accessories and
attachments necessary for printer programming and operation. Not listed here, are the
connection ports of circuit boards not externally accessable.
SWITCHES
Power Button Two position on/off switch that controls power flow to the system.
Print Button Two position on/off button that activates and deactivates print action.
Feed Button Two position on/off button that activates and deactivates feed action.
INDICATORS
Status LED Indicates the systems’ operational status.
DIP SWITCHES
1-1, 1-3 Interface settings.
1-2 Reserved.
1-4 Auto Feed function.
1-5 Head Check function.
1-6, 1-7, 1-8 Factory Clear and Error Message assignment.
POTENTIOMETERS
VR1 Eye-Mark Sensor adjustment.
VR2 Gap Sensor adjustment.
VR3 Print Position adjustment.
VR4 Print Darkness adjustment.
CONNECTION PORTS
DC Supply Port Connector permits 115V, 50/60 Hz supply via supplied cord.
Test Terminal For connecting the TP Test Module.