Service manual

Page 4-10
Section 4. Electric Checks and Adjustments
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
4.7 Feed/Backfeed Adjustment
STEP PROCEDURE
1. Turn On the power switch to display the Online screen.
2. Press the LINE key to set printer to the Offline screen.
3. Press the FEED key to feed a label. Confirm the end of the label is 2mm to
3mm from the peel bar.
If necessary, adjust the Offset potentiometer on the Dip Switch Panel to
obtain the correct position.
4. Turn Off the power switch.
Feed/Backfeed adjustment (label end distance from the dispenser bar) is made using the
OFFSET potentiometer on the Dip Switch Panel.
online
qty 000000
OFFSET
POTENTIOMETER
offline
qty 000000
2mm to 3mm
PEEL BAR
LABEL
RIBBON