Service manual

Page 3-7
Section 3. Interface Specifications
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
RS232C Serial Interface
Cable Requirements
* This connection at the host side of the interface would depend upon the pin that is being used as the
Ready/Busy signal by the driving software. Typically on a PC, it would be either CTS (pin 5) or DSR (pin 6)
on a DB-25 connector.
9BD52BDTSOHNOITCENNOCRETNIRETNIRP
11GF)dnuorGemarF(GF1
23 DR)ataDtimsnarT(DT2
32 DT)ataDevieceR(DR3
85 STC)dnesottseuqeR(STR4
74 STR)dneSotraelC(STC5
402TRD)ydaeRteSataD(RSD6
66 *RSD)ydaeRlanimreTataD(RTD02
57 GS)dnuorGemarF(GS7
DTR