Service manual

Page 2-38
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
LCD Panel Printer— Maintenance Mode
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place the DSW2-4 in the ON or up position.
3. Press the LINE and FEED key while simultaneously turning ON the power
switch. When the printer beeps, release the keys. The following screens will
appear.
4. Place the DSW-4 in the OFF position and the following screen will appear.
5. Press the FEED key to display the next screen.
6. Press the LINE key once to change the message from NONE to ALL.
7. Press the FEED key to clear the EEPROM. After a pause, the next screen will
appear.
8. Select the print label size by pressing the LINE key. The default is LARGE.
9. Press the FEED key for a test print. Press the FEED key again to stop printing.
counter clear
none
factory mode
initializing
rom v00.00.00.00
maintenance mode
diPSw2-4 on->off
counter clear
all
print size
small large
test print
press feed key