Service manual

Page 2-37
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
LCD Panel Printer— Default Setting Mode
Occassionally it is desirable to reset all printer configuration settings to their original default
conditions. This allows the operator to start the reconfiguration of the printer starting from
a known set of conditions.
To enter the Default Setting Mode press the FEED and LINE keys while simultaneuusly
power on the printer. When the printer emits one long beep release the FEED and LINE
keys.
Default Setting Mode
STEP PROCEDURE
1. Use the LINE key to select either YES or NO.
2. Once the desired setting is selected, press the FEED key to accept the
selection and the printer will reset to the original default conditions.
3. When the printer has completed the reset process, the Default Setting
Completed display will appear. The printer is now in the default
configuration.
To exit the Default Setting Mode, power the printer off, then back on.
default setting
yes no
default setting
completed