Service manual

Page 2-36
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Once you have selected the type of test label to be printed, use the FEED key to accept the
selection and the display advances to the Test Print Size display. This display allows you to
select the label width.
Test Print Size
10 CM
STEP PROCEDURE
1. Use the LINE key to select the label width. Each time the LINE key is
pressed, the label size advances 1 cm until it reaches a maximum
width of 10 cm at which point it will wrap to the smallest size of 4 cm.
2. Press the LINE key to accept the selection.
3. Press the FEED key to start printing test labels continuously.
4. Press the FEED key to stop the printer.
To exit the Test Print Mode, power the printer off, then back on.
test print Size
10 cm
press feed key to
stop printing
NOTE: This display does not
appear when a Memory Test Print
is chosen. Only a small Memory
Test Print can be printed.
LCD Panel Printer— Test Print Mode
STEP PROCEDURE
2. Use the LINE key to step the underline cusror to the type of test label you
wish to print. The choices are:
Configuration
Bar Code
Head Pattern
Memory
Factory
3. Once you have selected the type of test label to be printed, use the FEED key
to accept the selection and advance to the Test Print Size display. This display
allows you to select the label width.
See last pages in this section for
test label sample print-outs