Service manual

Page 2-35
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
LCD Panel Printer — Counters Mode
(Countinued)
STEP PROCEDURE
4. Use the FEED key to select the desired setting. If you only want to read the
counter value, select NO. If you want to read the counter and reset it to 0.0,
place the underline cursor under YES. Once the desired setting is selected,
press the FEED key to return to the Counter Mode display.
To exit the Counters Mode power the printer off, then back on.
counters mode
Test Print Mode
The Test Print Mode offers four different printer status labels for troubleshooting. If
DSW3-5 is OFF, the Test Print cycle must be initiated with a Print Start command.
This option allows you to print a test label. It is recommended that you print a test label
after you have changed any of the settings in the Advanced Mode. The test label allows
you to verify that you indeed did make the desired changes.
To enter the User Test Print Mode:
Test Print Mode
Configuration
STEP PROCEDURE
1. Power on the printer while pressing the FEED key. Release the FEED
key and the printer will display the Test Print Mode message on the
LCD panel.
test print mode
configuration