Service manual

Page 2-33
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
LCD Panel Printer— Service Mode
This selection allows the user to assign a priority for Print Darkness, Print Speed and Print
Offset.
Priority Setting
LCD Command
STEP PROCEDURE
1. Use the LINE key to step to the desired priority. If LCD is selected, the
setting established via the LCD display/menu system will be used for
an incoming label job, regardless of any dirrerent command settings.
If Command is selected, any commands in the label job will take
precedence and be used for printing the job and the LCD Display will
reflect the new setting.
2. Once the desired setting is selected, press the FEED key to accept the
setting and advance to the next display.
priority setting
lcd command
To exit the Service Mode power the printer off, then back on.
Service Mode
service mode