Service manual

Page 2-31
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
This display will only appear when Backfeed is enabled (DSW3-4 = OFF). The maximum
backfeed distance is 255mm.
Forward/Backfeed
Distance Default
STEP PROCEDURE
1. Use the LINE key to select either the Default or the Distance selection.
If Default is selected, the display steps to the Web acceleration selection.
2. If Manual setting is selected, use the LINE key to advance the distance to
the desired setting. Each time the LINE key is pressed, the distance will
advance 1mm. The maximum distance is 255mm.
3. Once the desired distance is set, press the FEED key to accept the setting
and advance to the next display.
forward/backfeed
distance default
LCD Panel Printer — Service Mode
forward/backfeed
distance XXXmm
This selection allows the printer to use either a Normal or Fast web acceleration. Large,
heavy, label rolls should use the Normal selection while smaller, lighter rolls can use the
Fast selection.
Web Acceleration
Fast Normal
STEP PROCEDURE
1. Use the LINE key to step the underline cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to accept the
setting and step to the next display.
NOTE: The Web Acceleration is automatically set to FAST if print
speeds of 10 or 12 ips are selected.
web acceleration
fast normal