Service manual

Page 2-10
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
2.4 LCD Panel Printer Configuration
The LCD Panel is used by the operator in conjunction with the LINE and FEED switches
to manually enter printer configuration settings. Many of the settings can also be
controlled via software commands and in the case of conflict between software and
control panel settings, the printer will always use the last valid setting. If you load a
label job that includes software settings and then enter a new setting via the LCD Panel,
the manually set values will be used by the printer. If you set the values manually and
then download a job with software settings, the software settings will be used.
There are elleven modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display
message is shown for each mode.
EDOMECNEUQESYEKYALPSIDLAITINIEGAP
edoMlamroNREWOP
ENILNO
000000:YTQ
11-2
edoMelbitapmoC0048MREWOP+8-2WSD
ENILNO
000000:YTQ
41-2
edoMdecnavdAREWOP+ENILEDOMDECNAVDA51-2
edoMtnirPtseTresUREWOP+DEEF
EDOMTNIRPTSET
NOITARUGIFNOC
53-2
edoMgnitteStluafeD
+DEEF+ENIL
REWOP
GNITTESTLUAFED
ONSEY
73-2
edoMecnanetniaM
+ENIL+NO4-2WSD
REWOP+DEEF
EDOMECNANETNIAM
FFO>-NO4-2WSPID
83-2
edoMdradnatS-noNraelC
+ENIL+NO7-2WSD
REWOP+DEEF
LOCOTORP.TLA
ETELPMOCTLUAFED
04-2
edoMpmuDxeHREWOP+NO4-2WSD
ENILNO
000000:YTQ
14-2
edoMdaolnwoDREWOP+6-2WSD
DAOLNWODHSALF
YDAER
24-2
edoMdaolnwoDresU
REWOP+NO7-2WSD
ENIL+
DAOLNWODRESU
YEKENILEHTSSERP
34-2
gnitteSrosneStuOlebaL
+DEEF+NO4-2WSD
REWOP
ROSNESTUOLEBAL44-2