Service manual

Page 2-7
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
2.2 Default Settings
Switch Selections
All switches are placed in the Off position (default) for shipping. This will result in the
following operating configuration:
Communications:
(1)
8 data bits, no parity, 1 Stop bit, 9600 Baud
(1)
Protocol:
(1)
Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Multi-Job
Mode: Batch Continuous
Label Sensor: Sensor Used
Backfeed: Enabled
External Signals: Enabled
(1) Active only if an RS232 Interface Card is installed in the printer.
Software Default Settings - The printer stores any software settings upon receipt
from the host and uses them until they are again changed by receipt of a command
containing a new setting. These settings are stored in non-volatile memory and are
not affected by powering the printer off. The printer may be reset to use the default
software settings by depressing the LINE and FEED keys simultaneously while
powering the printer on. You will be asked to confirm that you want the printer
default settings by selecting either YES or NO by using the LINE key to step the
underline cursor to the desired setting. If you select YES and press the FEED key, the
following default configuration will be stored:
Once the default operation is completed, a DEFAULT SETTING COMPLETED
message will be displayed on the LCD panel and three "beeps" will be heard. The printer
should be powered off while this message is being displayed. This saves the default
settings in the EEPROM where they will be automatically loaded the next time the
printer is powered on.
DEFAULT SETTING
COMPLETED
eS5848-M
ssenkraDtnirP2
deepStnirP.cesrep.ni6
ecnerefeRtnirP0000=latnoziroH,0000=lacitreV
oreZhsalS
eniL-nOotuAdelbanE