Service manual

Page 2-5
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
DSW3
ON
OFF
1 2 3 4
5 6 7 8
DSW3
ON
OFF
1 2 3 4
5 6 7 8
DSW3
ON
OFF
1 2 3 4
5 6 7 8
DSW3-3 SETTING
Off Sensor Used
On Not Used
DSW3-4 SETTING
Off Enabled
On Disabled
DSW3-5 SETTING
Off Enabled
On Disabled
Label Sensor Selection (DSW3-3): Enables or disables the Label Pitch sensor. If the
sensor is enabled, it will detect the edge of the label and position it automatically. If
it is disabled, the positioning must be under software control using Line Feed
commands.
Back-Feed Selection (DSW3-4): When Back-Feed is enabled, the printer will
position the label for dispensing and retract it before printing the next label. The
amount of backfeed is adjustable.
External Signal Interface
See Section 3: Interface Specifications for information on External Signals.
EXT Print Start Signal Selection (DSW3-5): Allows an external device to initiate
a label print for synchronization with the applicator. See Section 3: Interface
Specifications for a description of the signal level and requirements. When DSW3-
5 is On, the unit is in the Continuous print mode, Backfeed is disabled an External
Signals are ignored.
Dip Switch Settings