Service manual

Page 2-4
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Protocol Code Selection (DSW2-7): Selects the command codes used for protocol
control.
DSW2
ON
OFF
1 2 3 4
5 6 7 8
DSW2
ON
OFF
1 2 3 4
5 6 7 8
DSW2-7 SETTING
Off Standard
On Non-Std.
Dip Switch Settings
DSW2-6 SETTING
Off Disabled
On Enabled
Firmware Download (DSW2-6): Places the printer in the Firmware Download mode
for downloading new firmware into flash ROM.
DSW2
ON
OFF
1 2 3 4
5 6 7 8
M8400S Emulation Mode (DSW2-8): For emulating earlier series software
commands. Should be used only if problems are encountered when using existing
software. This switch will also affect the setttings selected by DSW1-7 and DSW1-8.
DSW3
ON
OFF
1 2 3 4
5 6 7 8
Backfeed Sequence Selection (DSW3-1): Backfeed is used to correctly position the
label for application and then retract the next label to the proper print position. This
operation can be performed immediately after a label is printed and used, or
immediately prior to the printing of the next label.
DSW2-8 SETTING
Off Disabled
On Enabled
DSW3-1 SETTING
Off Before
On After
Reserved for Future Use (DSW3-2):
DSW3
ON
OFF
1 2 3 4
5 6 7 8