Service manual

Page 6-33
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Replacing the Label Gap Sensor Board (Bottom 1/2) and “Eye-Mark”
Sensor (Reflective) Board
REMOVE (2) SCREWS,
(2) SPACERS AND
PLASTIC SHIELD
UNSNAP CABLE
HOLDER
SENSOR HARNESS @ (CN8)
CONNECTOR FOR SEN1, & SEN2
CONNECTOR FROM LABEL
GAP SENSOR BOARD INTO
SENSOR HARNESS
MARKED “SEN1”
Figs. 6-52
SEN1 CABLE
OPEN BUNDLE TIE
“EYE-MARK
SENSOR
LABEL GAP
SENSOR
(BOTTOM 1/2)
6-50
Fig.
6-51
Fig.
6-53
Fig.