Service manual

Page 6-30
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
6.13 Replacing the Head Open Switch
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the lid on the mechanical side of the printer.
3. Remove screw from cabinet side to allow printer halves to swing open for
access to the inside of the printer. Fig. 6-44
4. Remove (2) screws holding sensor to the cabinet side. Fig. 6-45
5. Open the bundle tie and unplug SEN5 connector from the sensor harness at
SEN5. Fig. 6-46 & 6-47
6. Draw the sensor through the access hole.
7. Replace sensor and reattach to the cabinet side. Feed sensor connector back
through the access hole and fasten bundle tie. Reattach to sensor harness at
SEN5.
8. Close the printer halves and replace the locking screw.
9. Reconnect the power cable.
To remove and replace the Head Open Switch perform the following steps:
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN
6-44
Fig.