Service manual

Page 6-28
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
6.12 Replacing the Cover Open Switch
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the lid on the mechanical side of the printer.
3. Remove screw from cabinet side to allow printer halves to swing open for
access to the inside of the printer. Fig. 6-38
4. Twist open the cable tie and unplug SEN6 connector from the sensor harness
at SEN6. Fig. 6-39 & 6-40
5. Remove the screw securing the ribbon motion sensor and move the sensor
just enough to allow the connector SEN6 on the end of the sensor to slide
through the access hole. Fig. 6-41 & 6-42
6. Remove (2) screws holding sensor to the cabinet side. Fig. 6-43
7. Replace sensor and reattach to the cabinet side. Feed sensor connector back
through the access hole and replace tie. Reattach to sensor harness at SEN6.
8. Remount the ribbon motion sensor removed in Step 5.
9. Close the printer halves and replace the locking screw.
10. Reconnect the power cable.
To remove and replace the Cover Open Switch perform the following steps:
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN
6-38
Fig.