Service manual

Page 6-14
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove screw from cabinet side to allow printer halves to swing open for
access to the inside of the printer. Fig. 6-17
3. Detach (2) connectors from the display panel PCB.
4. Remove (4) panel mounting screws. Note that one screw secures a ground
wire. Note location for reassembly. Fig. 6-18
5. Remove and replace the LCD Display Panel. Reattach the connectors.
6. Close the printer halves and replace the locking screw.
7. Reconnect the power cable.
6.6 Replacing the LCD Display Panel
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN
6-17
Fig.
6-18
Figs.
REMOVE (4)
MOUNTING SCREWS
DETACH (2)
CONNECTORS
GROUND WIRE
LCD DISPLAY
PANEL