Service manual

Page 6-13
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
6.5 Replacing the Service Board
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (5) screws securing the back panel to the cabinet. Fig. 6-15
3. Detach the connector from the Service Board. Fig. 6-16
4. Remove (4) screws to detach defective service board from bracket.
5. Reinstall replacement service board reversing the above steps.
NOTE: Many of the components on this board are susceptible to damage by static
electricity. To avoid damage from static electricity, do not unpack new circuit boards
from anti-static bags until instructed to do so and use a wrist grounding strap.
REMOVE (5) SCREWS TO
DETACH BACK PANEL
REMOVE (4)
SCREWS TO DETACH
SERVICE BOARD
DETACH
CONNECTOR
6-15
Fig.
6-16
Figs.