Service manual

Page 1-10
Section 1. Overview and Specifications
SATO M-8485Se Standard Print Engine
Service Manual
PN 9001080
Rev. A
Adjusting the Label Sensor
The M-8485Se printers can position labels using either a label gap (transmissive) or an "Eye-
Mark" (reflective) sensor. The sensor used is selected by DSW2-2. The gap sensor position
can be adjusted over a limited range. In addition, the signals from the sensors can be
adjusted using the LCD panel to compensate for different liner opacities and/or "Eye-Mark"
reflectance values.
eS5848-M
htdiWlebaLxaM
)renilsedulcni(
)mm431("72.5
htdiWtnirPxaM)mm821("0.5
rosneSpaG
egnaRtnemtsujdA
)mm86otmm41("76.2ot"5.0
aerAtnirP-noN)mm3("21.0
PRINT HEAD
INSIDE FRAME
INSIDE LABEL EDGE
MAXIMUM WIDTH
MAXIMUM PRINT WIDTH
GAP SENSOR
ADJUSTMENT
NON-PRINTABLE AREA
EYE-MARK ON BACK SIDE
OF LINER
MINIMUM WIDTH = 0.125" (3 mm)
MINIMUM LENGTH = 0.5" (12 mm)