Service manual

Page 6-4
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
6.3 Replacing the Power Supply
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove locking screw from the side of the cabinet to allow the printer to
swing open for access to the fuse(s) Fig.6-3
3. Remove (2) screws holding the power supply to the back of the cabinet and
(1) screw from inside the cabinet. Fig. 6-4 & 6-5
4. Remove the defective power supply. Fig. 6-6
5. Detach (5) connectors from the power supply. Figs. 6-7
6. Install a new power supply.
7. Reattach connections and screws previously removed.
8. Close the printer sections and replace the locking screw.
9. Reconnect the power cable.
6-3
Figs.
The Power Supply is a non-repairable component with no service parts and is replaced as a
complete assembly.
To remove and replace the Power Supply, perform the following steps:
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN