Service manual

Page 6-3
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Replacing Fuses
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove locking screw from the side of the cabinet to allow the printer to
swing open for access to the fuse(s) Fig.6-2
3. Replace the defective fuse with one of equal rating. Do not use a fuse with
a higher rating.
4. Close the printer sections and replace the locking screw.
5. Reconnect the power cable.
6.2.2 Removing and Replacing the Internal Fuse(s)
Required: T3.15 Amp, 250 V Fuse or
T 1 Amp, 250 V Fuse
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN
FUSES
6-2
Figs.
MAIN PCB