Service manual

Page 6-2
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. On the back of the printer locate the fuse cap. Unscrew the fuse cap and
remove the defective fuse. Fig.6-1
3. Replace the fuse with one of equal rating (F15 Amp, 250 V) and screw the
fuse cap back. Do not use a fuse with a higher rating.
4. Reconnect the power cable.
Fuse replacement is described in the following section.
 6.2.1 Removing and replacing the Main Power Fuse
 6.2.2 Removing and replacing the internal Fuse(s)
6.2.1 Removing and Replacing the Main Power Fuse
Required Equipment: F15 Amp, 250 V Fuse
6.2 Replacing Fuses
NOTE: Before replacing a fuse, determine the
cause of the overload condition.
REAR COVER
FUSE
6-1
Fig.