Service manual

Page 5-15

Section 5. Mechanical Adjustments

PN 9001080

Rev. A

SATO M-8485Se Standard Print Engine

Service Manual

5.8 Peel Bar Adjustment

STEP PROCEDURE

1. Loosen the set screw on either end of the peel bar and adjust to obtain an

equal distance between the platen roller and the peel bar.

Figs. 5-19

Required Equipment:  5.5mm Open End Wrench

 #2 Phillips Screwdriver

The distance between the dispense bar and the platen roller should be 0.5-1mm and equal on

both the inside of the platen/peel bar and the outside of the peel bar.

To adjust perform the following.

PLATEN ROLLER

(COVER SHOWN

REMOVED)

PEEL BAR

0.5 - 1mm

ADJUST SCREW

ON EITHER END

PLATEN ROLLER

5-19

Figs.