Service manual

Page 5-14
Section 5. Mechanical Adjustments
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
5.7 Feed Roller Adjustment (Label Tracking)
STEP PROCEDURE
1. Load the ribbon and label stock into the printer.
2. Loosen the set screw and turn the eccentric nut CW or CCW. Fig. 5-18
Rotating CW moves the Feed Roller Assembly forward and labels will track
towards the inside.
Rotating CCW moves the Feed Roller Assembly backward and labels will track
towards the outside.
Tighten the (2) screws after adjusting.
3. To increase pressure between the upper and lower rollers, adjust the two
screws on the media lid.
Adjust the height of the screws to 5mm. Fig. 5-17
Required Equipment:  10mm Open End Wrench
 #2 Phillips Screwdriver
Used for fine tuning. Adjusts pressure between upper and lower rollers.
ECCENTRIC NUT LOCATED
ON MEDIA RAMP ASSEMBLY
TURN CW OR CCW
5
MM
MEDIA LID
COVER
MEDIA LID
COVER
F
ig. 5-17
F
ig. 5-18