Service manual
Page 1-9
Section 1. Overview and Specifications
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
1.8 Adjusting the Label Sensor
RIBBON GUIDE
PLATE
LABEL GAP
SENSOR
ADJUST SLOT
SENSOR POSITION
SCREWS
The label gap (transmissive) sensor can be positioned over a limited range. The movable
sensor assembly is mounted on the Label Hold Down and is held in position by two screws.
To adjust the position of the sensor, both screws must be loosened and the sensor moved to
the desired position in the slot and then the screws retightened. Adjustments to compensate
for different liner opacity are done with the LCD panel.