User`s manual

52
Chapter 3 Configuration Setting Compatibility
• SATO setting: REPRINT W/FEED
This selection specifies whether or not the printer will print the last printed
label stored in memory when the FEED key is pressed in the Normal
Online mode.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported
• SATO setting: FORWARD/BACKFEED DISTANCE
This display only appears when Backfeed is enabled (DSW3-4 = OFF)
0 - 255 mm.
Printronix setting:
SL5000r/T5000r: MEDIA CONTROL X Paper Feed Shift
SL4M/T4M: MEDIA SETUP X Tear Off Adjust
• SATO setting: EURO CODE
This selection allows the user to specify the hexadecimal code for the
character which is replaced with the Euro Character. Default is 0xD5.
Printronix setting:
SL5000r/T5000r and SL4M/T4M: STGL SETUP X Euro Code
• SATO setting: SELECT LANGUAGE
This selection allows the user to select the character set used by the
printer LCD menu (English, French, German, Spanish, Italian, and
Portuguese).
Printronix setting:
SL5000r/T5000r: PRINTER CONTROL X Display Language
SL4M/T4M: PRINTER SETUP X Display Language
• SATO setting: PRIORITY SETTING
This selection allows the user to assign a priority for CS (Print Speed), #5
(Print Darkness), A3 (Base Reference Point), IG (Sensor Type), PM (Print
Mode), and PH (Print Type). If LCD is selected, the setting established via
the LCD display/menu system is used for incoming label job, regardless
of any different command settings. If Command is selected, any
commands in the label job takes precedence and is used for printing the
job. The LCD display reflects the new setting.
Printronix setting:
SL5000r/T5000r has menus to ignore each command separately
(see page 13).
SL4M/T4M: STGL SETUP X Priority Setting