User`s manual

LCD Panel, Card Mode
51
• SATO setting: IGNORE CR/LF
This selection tells the printer to strip out all carriage return/line feed pairs
(CRLF) from the data stream, including graphics and 2D bar codes. It is
used primarily to maintain compatibility with earlier models of SATO
printers.
Printronix setting: STGL SETUP X Ignore CR/LF
• SATO setting: CHARACTER PITCH
This selection allows you to set the default character pitch to either fixed
character spacing or proportional character spacing. This command can
be overridden by the <ESC>PR or <ESC>PS Character Pitch
Commands.
Printronix setting: STGL SETUP X Character Pitch
LCD Panel, Card Mode
• SATO setting: CARD MODE
The Card Mode allows the operator to manage the Expanded Memory
(PCMCIA Card or Internal Expanded Flash ROM). Typical operations are
copying data between cards, formatting cards.
Printronix setting: Copying is supported by FlashFile upload in PPM.
LCD Panel, Service Mode
• SATO setting: GAP [X.X V] EYE [X.X V] INPUT [X.X V]
This adjustment allows you to manually set the threshold voltage level,
between the maximum and minimum light levels. If the value entered for
the bottom line setting is “0.0V,” then the printer automatically calculates
the setting when the first label is fed. This happens after the printer is
powered on or the head is closed.
Printronix setting:
SL5000r/T5000r: CALIBRATE CONTROL X Gap/Mark Tresh
CALIBRATE CONTROL X Auto Calibrate
SL4M/T4M: SENSOR SETUP X Gap/Mark Tresh
SENSOR SETUP X Run Auto-Cal
• SATO setting: ONLINE FEED
This selection specifies whether or not the printer automatically feeds a
blank label when it is placed in the Online mode.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported
• SATO setting: FEED ON ERROR
This selection specifies whether or not the printer feeds a blank label
automatically when an error condition is cleared.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported