User`s manual

DIP Switches
49
• SATO setting: DSW3-3
Label Sensor Selection. Enables or disables the Label Sensor.
Printronix setting:
SL5000r/T5000r: CALIBRATE CONTROL X Gap/Mark Sensor
SL4M/T4M: SENSOR SETUP X Gap/Mark Sensor
• SATO setting: DSW3-4
Back-Feed Selection. When Back-Feed is enabled, the printer positions
the last printed label for dispensing and retracts it before priting the next
label.
Printronix setting:
SL5000r/T5000r: MEDIA CONTROL X Media Handling
SL4M/T4M: MEDIA SETUP X Media Handling
• SATO setting: DSW3-5
EXT Print Start Signal Selection. Allows an external device to initiate a
label print for synchronization with the applicator.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported
• SATO setting: DSW3-6
External Signal Type Selection.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported
• SATO setting: DSW3-7
Both the polarity and signal type (level or pulse) of the external print
synchronizing signal can be selected.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported
• SATO setting: DSW3-8
Repeat Print via External Signal. Allows the applicator to reprint the last
label of the print job.
Printronix setting:
SL5000r/T5000r: Supported through GPIO
SL4M/T4M: Not supported