User`s manual

48
Chapter 3 Configuration Setting Compatibility
• SATO setting: PITCH
Potentiometer to adjust home position of the label (+/-3.75 mm). Affects
stop position of the label feed, print position, and dispense position.
Printronix setting:
SL5000r/T5000r: MEDIA-CONTROL X Ver Image Shift
SL4M/T4M: MEDIA SETUP X Ver Image Shift
DIP Switches
• SATO setting: DSW1
Serial Port Settings
Printronix setting:
SL5000r/T5000r: SERIAL PORT menu
SL4M/T4M: INTERFACE X Serial Port
• SATO setting: DSW2-1
Print Mode Selection. Selects between direct thermal printing on
thermally sensitive paper and thermal transfer printing using a ribbon.
Printronix setting:
SL5000r/T5000r: MEDIA CONTROL X Print Mode
SL4M/T4M: MEDIA SETUP X Print Mode
• SATO setting: DSW2-2
Sensor Type Selection. Selects between the use of a label gap or a
reflective Eye-Mark detector.
Printronix setting:
SL5000r/T5000r: CALIBRATE CONTROL X Gap/Mark Sensor
SL4M/T4M: SENSOR SETUP X Gap/Mark Sensor
• SATO setting: DSW2-4
Hex Dump Selection. Selects Hex Dump Mode.
Printronix setting:
SL5000r/T5000r and SL4M/T4M: DIAGNOSTICS X Hex Dump Mode
• SATO setting: DSW2-6
Firmware Download. Places the printer in the Firmware Download mode
for downloading new firmware into flash ROM.
Printronix setting: Download Mode/PPM
• SATO setting: DSW2-7
Protocol Code Selection. Selects the Standard or Non-Standard
command codes used for protocol control.
Printronix setting:
SL5000r/T5000r and SL4M/T4M: STGL SETUP X Protocol C Code
• SATO setting: DSW3-1, DSW3-2
Backfeed Sequence. Backfeed is used to correctly position the label for
application and then retract the next label to the proper print position.
Possible modes are Continuous, Tear-Off Strip, Peel Off, and Cut.
Printronix setting:
SL5000r/T5000r: MEDIA CONTROL X Media Handling
SL4M/T4M: MEDIA SETUP X Media Handling