User`s manual

Supported General Commands

Paa – Character Pitch

Designates the number of dots between characters (all except raster fonts).

PR – Fixed Font Spacing

Returns the rpinter to fixed character spacing mode.

PS – Proportional Font Spacing

Places the printer in the proportional character spacing mode.

Qaaaaaa – Print Quality

Specifies the total number of labels to print.

RDabb,ccc,ddd,nn...n – Font Type (SL5000r/T5000r)

Specifies the internal AGFA raster fonts. The STGL Agfa fonts will match the

SATO raster font characteristics. Using the SATO <ESC>RD command, one

of two agfa fonts can be selected. It allows specification of both width and

height of the font (in dots or as point-size) and whether it should be printed in

bold/normal. The font-style can be either CG Times (16 999 dots or

P08 - P72) or CG Triumvirate (16 -1 999 dots or P08 - P72).

RDabb,ccc,ddd,nn...n – Font Type (SL4M/T4M)

NOTE:

By default some fonts are not present in the printer. Make sure the

font is available in the printer before using it.

Allows printing of Scalable fonts (Agfa/TrueType) using the <ESC>RD

command. It allows specification of both width and height of the font (in dots

or as point size), and the character set.

a = Font Type ID as described in the Raster fonts Table 2.

b = Character Set ID as described in the Character sets Table 3.

c = Font Style is always 0 (zero).

d = Horizontal size: 004 to 999 dots/P02 to P99 points.

e = Vertical size: 004 to 999 dots/P02 to P99 points.

n = Print data.