User`s manual

20
Chapter 1 STGL SETUP MENU (SL4M/T4M)
Reference DPI (SL5000r/T5000r)
When parameters are defined as number of dots, these values translate to
the actual printhead resolution as necessary. Graphics and downloaded
bitmaps will not be scaled since this usually does not result in an image that is
acceptable to users.
• 203 (default). Incoming parameters are assumed to be in 300 DPI. On a
300 DPI printer, they will be scaled.
• 305. Incoming parameters are assumed to be in 305 DPI. On a 203 DPI
printer, they will be scaled.
To provide compatibility with a M8450 printer, the following selections are
available:
• M8450 1xDotExp. Incoming parameters area assumed to be in 300 DPI.
• M8450 2xDotExp. Incoming parameters area assumed to be in 150 DPI.
• M8450 3xDotExp. Incoming parameters area assumed to be in 100 DPI.
SensType Cmd(IG) (SL5000r/T5000r)
Ignores Sensor Type command. This command is used to select the
Reflective/Transmissive/No Sensor.
Slash Zero
This parameter allows you to print the numeral “0” with or without the slash.
• Disable (default). Zero is printed without a slash.
• Enable . Zero is printed with a slash.
Speed Cmd (CS) (SL5000r/T5000r)
Ignore Speed Commands.
Status Reply Time (SL4M/T4M)
This setting defines when the emulation sends status responses. This setting
only applies to the status 4 protocol, and will only be available when the
selected protocol is status 4.
• Enq (default). The status is only sent on receipt of an ENQ command.
• Cycle . The status is sent out unsolicited (no ENQ command needed)
every 750 mS.
Translate &%..&% (SL5000r/T5000r)
This setting allows replacing of the string &%CC&% by one single control
character with a hex value equal to that of string CC.
• No (default). Hex Transparency option disabled.
• Yes . Hex Transparency option enabled.
This option might be extended in the future to use user-defined introducers.