User`s manual

ManualsBrandsSATO ManualsComputer equipmentM8450

Chapter 1

STGL SETUP MENU (SL4M/T4M)

Item No Check (SL4M/T4M)

This setting defines how the emulation handles the Item No error detected in

the data stream. This setting will only be available when the selected protocol

is status 5.

•

Disabled (default). Item No error handling is performed.

•

Cancel. On an Item No error the printer will go offline and indicate the

error on the front panel. When the user puts the printer back online, the

item/job that has the BBC error will automatically cancel.

•

Resume. On an Item No error the printer will go offline and indicate the

error on the front panel. When the user puts the printer back online, the

item/job that has the Item No error will automatically resume.

The status 5 command to cancel or resume an item will take precedence over

this setting. E.g. if the host command is received before the user puts the

printer back online, the printer will go back online and resume or cancel the

item as defined by the host command.

Mem Select (CC1) (SL4M/T4M)

•

Card (default). When selected, the “a” parameter within the STGL CCa

command refers to the memory type as follows:

1 = External Memory Cartridge

2 = Flash ROM

•

Memory. When memory is selected, the “a” parameter within the STGL

CCa command refers to the memory type as follows:

1 = Flash ROM

2 = External Memory Cartridge

Printer Model (SL5000r/T5000r)

This setting indicates whether or not to emulate certain legacy models. These

models have the following differences: Bolder M-Font and Larger WB-Font.

•

CL-Series (default). Emulate current CL-Series models.

•

CL-Legacy. Emulate older legacy printer models.

Priority Setting (SL4M/T4M)

This menu option allows the printer to ignore several configuration commands

in host data. This allows using their corresponding front panel settings,

without being overridden by host commands.

•

Command (default)

•

LCD (Internal). Use front panel settings instead of the following

commands: CS (Print Speed), #E (Print Darkness), A3 (Base Reference

Point), IG (Sensor Type), PM (Print Mode), PH (Print Type).