User`s manual

STGL SETUP Submenus

DlProtCodCmd(LD) (SL5000r/T5000r)

Ignores downloading of user-defined Protocol Control Codes.

Euro Character

This selection allows the user to specify the hexadecimal code for the

character which is replaced with the Euro Character. Default is 213 (0xD5).

•

213 (default)

•

0 – 255. Character to replace with Euro Character.

History Buffer (SL4M/T4M)

This setting defines whether the history buffer is to be stored to non-volatile

RAM. This setting is available only when the selected protocol is status 5.

•

Temporary (default). The state of the history buffer will not be stored to

NOVRAM. When the printer is turned off or looses power, the state of the

history buffer will be lost. On power-up, the history buffer will initialize and

be empty.

•

Persistent. The history buffer is stored to non-volatile memory. When the

printer is turned on after power down or loss, the history buffer will

initialize with the values stored in NOVRAM.

Hor. BaseRefPoint

This setting changes the horizontal base reference point for all subsequent

label jobs. Its effect is identical to the <ESC>A3 Base Reference point

command.

•

0 dots (default)

•

- 9999 to 9999

Ignore CR/LF

This selection tells the printer to strip out all carriage return/line feed pairs

(CRLF) from the data stream, except for Graphics and 2D bar code data. It is

used primarily to maintain compatibility with earlier models of SATO printers.

•

No (default). Allow CR/LF in the data stream.

•

Yes. Remove all CR/LF from the data stream.