User`s manual

16
Chapter 1 STGL SETUP MENU (SL4M/T4M)
Comm. Protocol (SL5000r/T5000r)
NOTE: This printer supports bi-direction communication through Serial,
Parallel, USB, and Ethernet interfaces.
This setting defines the protocol used for serial communication.
• Standard (default). The standard communication protocol is used as
configured in the Data Protocol menu (under the SERIAL PORT main
menu).
• Status 3. SATO communication status 3 protocol.
• Status 4. SATO communication status 4 protocol.
• Status 2. SATO communication status 2 protocol.
NOTE: When using a protocol other than Standard over the serial interface,
the Data Protocol setting of the Serial port interface should be set to
DTR. Any other Serial Data Protocol would interfere with the SATO
Status-Protocol.
Comm. Protocol (SL4M/T4M)
NOTE: This printer supports bi-direction communication through Serial,
Parallel, USB, and Ethernet interfaces.
This setting defines the protocol used for bi-directional communication.
• Standard (default). The standard communication protocol is used as
configured in the Data Protocol menu under INTERFACE menu X Serial
Port submenu.
• Status 2. SATO communication status 2 protocol.
• Status 3. SATO communication status 3 protocol.
• Status 4. SATO communication status 4 protocol.
• Status 5. SATO communication status 5 protocol.
NOTE: When selecting a protocol other than Standard, the Data Protocol
setting of the Serial Port interface automatically sets to DTR. Any
other Serial Data Protocol would interfere with the SATO Status-
Protocol.
Cut Cmds ( ∼ ,NUL) (SL5000r/T5000r)
Ignore all Cut Commands.
NOTE: SATO printers cut after each page per default when the Cut option is
enabled.
With STGL, the default behavior is not to cut after each page, only upon
receipt of a cut command. If this behavior is required, the Media Handling
setting in the Media Control menu should be set to “Cut.” In addition, the
STGL Cut Commands menu must be set to ignored.
Darkness Cmd (#E) (SL5000r/T5000r)
Ignore Darkness (Intensity) Commands.