Specifications

Operation Manual Section 3. Configuration

SATO M-84PRO Page 3-7

DEFAULT SETTINGS

SWITCH SELECTIONS

All switches are placed in the Off default position for shipping. This will result in the

following operating configuration:

SOFTWARE DEFAULT SETTINGS

The printer stores the software settings upon receipt and uses them until they are

again changed by receipt of a command containing a new setting. These settings are

stored in non-volatile memory and are not affected by powering the printer off. The

printer may be reset to use the default software settings by depressing the LINE and

FEED keys simultaneously while powering the printer on. This will result in the

following default configuration:

Once the default operation is completed, a DEFAULT COMPLETED message will be

displayed on the LCD panel. The printer should be powered off while this message is being

displayed (or after the beep is heard. This saves the default settings in the non-volatile

memory where they will be automatically loaded the next time the printer is powered on.

Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud

Protocol: Ready/Busy

Sensor: Gap Sensor

Receive Buffer: Multi Job

Mode: Batch/continuous

Label Sensor: Sensor Used

Backfeed: Enabled

External Signals: Enabled

M-84PRO

Print Darkness 3

Print Speed 6 ips (3 ips for M-84PRO-6)

Print Reference Vertical = 0000, Horizontal = 0000

Zero No Slash

Print Offset +0

Ignore CR/LF Disabled

Character Pitch Proportional

Ignore CAN/DLE Disabled

Auto On Line Enabled

Feed on Error Enabled

Feed Reprint Disabled

Priority Command

Language English

CC1 Mem Select Card

Eurocode D5

DEFAULT COMPLETED