Installation guide

INSTALLATION GUIDE
V
Manufacturer’s Instructions
The user must observe the following precautions in installing and operating this device:
1. Operate the equipment in strict accordance with the manufacturer’s instructions for the model.
2. Plug the printer into a properly grounded wall outlet and use, unmodified, the power cord supplied with the unit.
3. Always operate the printer with all factory-installed covers on the unit.
4. Make no modification to the equipment that would affect its meeting the specified limits of the FCC Rules.
5. Maintain the equipment in a satisfactory state of repair.
6. Use a shielded and properly grounded I/O cable to ensure compliance of this unit to the specified limits of the
FCC Rules.
User’s Responsibility
The user is ultimately responsible for correcting problems arising from harmful radio frequency emissions from
equipment under his or her control. If this equipment does cause interference to radio or television reception
(which as specified can be determined by turning the printer off and on), SATO encourages the user to try to
correct the interference by changing one of the following:
• Equipment orientation
• Equipment location
• Power source
All of these responsibilities and any others not mentioned are exclusively at the user's expense.
If necessary, the user should consult SATO for additional suggestions.
Note: If it is determined that equipment operation is causing harmful interference, the equipment operator may be
required to stop operating the equipment until the interference problem is corrected.