Installation guide

A P P E N D I X E
E-2
BURSTER UNIT INSTALLATION, CONTINUED
4. Remove the exit guide A by removing the four
screws. (Figure E-3)
Figure E-3
5. Remove the exit guide B by removing the two screws.
(Figure E-4)
Note: The exit guide A and B are no longer
necessary together with the screws when
the burster unit is installed. Store it, if
necessary.
Figure E-4
6. Install the paper guide on to the burster unit.
7. Install the harness on to PWB-F to the PJ-7
connector. Install the harness in the cable clamp.
(Figure E-5)
8. Install the burster unit with 2 screws and 2
connectors.
9. Connect the harness to the burster.
10. Connect the burster home sensor harness, located
in the harness.
11. Install all covers in their original positions.
12. Stick the Burster Jam Removal Instruction Label to
the inside of the left cover.
13. Close the left door.
Figure E-5
A
B