Installation guide

A P P E N D I X D
D-4
SWING GUIDE INSTALLATION, CONTINUED
11. Swing the front plate upward and secure up against
the bottom frame of the printer against the
stationary magnet.
12. Insert the guide film into the hole in the upper part of
the swing guide (front side).(Figure D-8)
Figure D-8
13. Lower the front plate down to the swing guide
assembly and secure with the two knurled screws.
14. Install the two support plates. (Figure D-9)
Figure D-9
15. Connect the swing guide drive gear assembly with
the one connector. (Figure D-10)
16. Install the cover to the swing guide assembly (front
side) by fastening the two screws.
17. Install the paper guide at 30mm inside from the
paper edge.
Note: When installing the burster unit, redo the
connection of the burster unit.
18. Install the lower-left cover (black) by fastening the
four screws, and close the front door.
SUPPORT PLATES
SCREW SCREW
GUIDE FILM
Figure D-10