Installation guide

A P P E N D I X D
D-2
SWING GUIDE INSTALLATION, CONTINUED
2. Remove the blind plate from the printer frame for
the swing guide drive motor assembly located
above the PWB-F/SC board by removing the two
screws.
Note: The removed blind plate is no longer
necessary. Store it, if necessary.
3. Position the swing guide drive motor assembly
while shifting it to the right of the printer body by
temporarily fastening the three screws. (See
Figure D-2)
4. Connect the connector (6P) from the swing guide
drive motor assembly to PWB-F (PJ6). (See
Figure D-2)
5. Install the two paper guides to the Printer body by
fastening the five screws.(See Figure D-3)
The two paper guides (L and R) are identical
with each other .
6. Mount the Magnet assembly to the printer body as
shown in Figure D-4 and fasten with two screws.
Figure D-4
Figure D-3
Figure D-2