Installation guide

INSTALLATION GUIDE
30
5.8 Entering Maintenance Mode
5.8.1 Turning the Controller's Power Off
Before entering Maintenance mode you must first turn off power to the controller. This is necessary when
performing maintenance functions that may require sudden power off and on conditions. Turning power off
to the controller allows you to work freely without damaging the controller:
1. Turn the Printer Off from the POWER LED switch.
2. Open the front door.
3. Locate the power strip located in the controller cabinet above the main power supply shelf.
4. Toggle the (RED) lighted on/off switch until the switch has been extinguished (power off).
5. Confirm that the position of the panel switch located near the mechanical counter points toward
MAINT (Figure 5-22).
Figure 5-22
5.8.2 Turning the Printer's Power On
The printer can now be turned on/off with the POWER LED switch located on the operator panel
(see Figure 5-23).
Figure 5-23.
• To turn the printer Off, press the POWER LED switch for a minimum of 10 seconds.
• To turn the printer On, press the POWER LED switch.
0 1 2 3 4 5 6
MAINT
REMOTE